Vivotek FD8372 User Manual download pdf (Page 9)

EN - 8

POW

ION

CEIVE

PARTITIO

Network Deployment

1. Connect RJ45 Ethernet cable to a switch.

Use a Category 5 Cross Cable when your

network camera is directly connected to PC.

2. Connect the AC cables from the terminal

block as an alternate power source. The IO

cables are user-supplied.

Ethernet

Non-PoE Switch

Pin 1

Pin 2

AC 24V±10%

Black

Red

General Connection (without PoE)

Ceiling mount

1. Attach the supplied alignment sticker to the ceiling.

2. Using the circle marks on the sticker, drill at least 2 pilot holes symmetrically on each side into the

ceiling. Then hammer the four supplied plastic anchors into the holes.

3. Through three or four holes on the mounting plate, insert the supplied screws into the corresponding

holes and secure the mounting plate with a screwdriver.

4. Feed the cables through the triangular cutout A or side opening B. If you want to use hole B, remove

the side cover using a screwdriver. Secure the camera base to the mounting plate with three supplied

screws.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Vivotek FD8372 User Manual Page 9