Vivotek IP32133 User Manual download pdf (Page 41)

- 40 -

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Network settings

Any change made to this page will make the system restart to validate. Make sure

every field is correctly typed before clicking on

"Reset IP address at next boot", the default status is checked to eliminate

incautious mistakes during installation. However it is very annoying to perform

software installation whenever Network Camera starts. Once the network settings,

especially the IP address, are correct, uncheck this option to use permanently. This

option can also be disabled using the Installer program. Once the option is disabled,

Network Camera will skip installation at the next boot and the Installer program will no

longer find the installed units. That implies that Network Camera cannot be accessed if

no one remembers the IP address, except by restoring factory default settings.

However, with this option disabled Network Camera can automatically operate

normally after restarting in case of losing power.

General

“IP address”, it is necessary for network identification.

“Subnet mask”, it is used to determine if the destination is in the same subnet. The

default value is “255.255.255.0”.

“Default router”, it is the gateway used to forward frames to destinations in different

subnet. Invalid router setting will fail in transmission to destinations in different

subnet.

“Primary DNS”, primary domain name server who translates names to IP addresses.

“Secondary DNS”, secondary domain name server to backup the primary one.

HTTP

“Http port”, it can be other than default port 80. Once the port is changed, users must

be informed for successful connection. For instance, when the administrator changes

the HTTP port of Network Camera whose IP address is 192.168.0.100 from 80 to 8080,

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 70 71

No comments

Vivotek IP32133 User Manual Page 41