Vivotek IP8133 Specifications download pdf (Page 7)

VIVOTEK

User's Manual - 7

WPS

Wireless Connection: Using the WPS Button

1� Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi

Protected Setup) functions� WPS enables easy setup with compatible APs�

2� Disconnect your LAN cable, and wait for the LED to turn red�

3� Press the WPS button for 1 second� You can then hear vocal instructions (in English)

from the camera speaker�

4� Press and hold down the WPS button on your AP

(some router/AP will have a virtual button on their

management software instead)� Refer to your AP's

documentation for details using its WPS functions�

When WPS conguration is done, wireless connectivity will be established and the

security encryption, such as WEP or WPA-PSK, will be synchronized with the AP�

Use the IW2 utility to nd the camera. As for IP setting, the camera's use of DHCP

or static IP is determined by your conguration on the network camera via the web-

based conguration of rmware. The camera's default is DHCP.

NOTE:

WPS Button

Wireless AP

1. WPS may not work if your AP is congured with a "hidden" SSID.

2� If no WPS-enabled AP is detected, the camera will repeat vocal instructions by

every 20 seconds, and if the camera still can not detect an AP after 2 minutes,

the wireless setup will be cancelled�

3. If a camera is assigned with a xed IP outside the AP's network segment, wireless

setup will fail�

4� A wired connection always has a higher priority, and hence wireless setup will not

take effect when the RJ45 LAN port is connected�

1 2 3 4 5 6 7 8 9 10 11 12 ... 160 161

No comments

Vivotek IP8133 Specifications Page 7