Vivotek PT3114 Installation Guide download pdf (Page 8)

- 7 -

www.vivotek.com

Installation

In this manual, "User" refers to whoever has access to the Network Camera, and

"Administrator" refers to the person who can configure the Network Camera and grant

user access to the camera.

Hardware installation

Please verify that your product package contains all the

accessories listed in the foregoing Package Contents.

Depending on the user’s application, an Ethernet cable

may be needed. The Ethernet cable should meet the specs

of UTP Category 5 and not exceed 100 meters in length.

Upon powering up, the front red LED will become lighted first and then the device will go

through booting process. During the booting process, red, blue and green LEDs will be

on. After booted, the Network Camera will standby for getting IP address. After getting IP

Address, the green LED will blink every second. If the red LED is blinking, please check

the network connections.

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet

cable plug in the power adapter. If the LED turns out to be steady red, go to next

paragraph “Software installation”.

Connect the power adapter jack to the Network

Camera before plugging in to the power socket. This will

reduce the risk of accidental electric shock.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 76 77

No comments

Vivotek PT3114 Installation Guide Page 8